MOBILE |
Mobile module |
4G (LTE) – Cat 4 up to 150 Mbps, 3G – Up to 42 Mbps, 2G – Up to 236.8 kbps |
SIM switch |
2 SIM cards, auto-switch cases: weak signal, data limit, SMS limit, roaming, no network, network denied, data connection fail, SIM idle protection |
Status |
Signal strength (RSSI), SINR, RSRP, RSRQ, EC/IO, RSCP, Bytes sent/received, connected band, IMSI, ICCID |
SMS |
SMS status, SMS configuration, send/read SMS via HTTP POST/GET, EMAIL to SMS, SMS to EMAIL, SMS to HTTP, SMS to SMS, scheduled SMS, SMS autoreply, SMPP |
USSD |
Supports sending and reading Unstructured Supplementary Service Data messages |
Black/White list |
Operator black/white list |
Multiple PDN |
Possibility to use different PDNs for multiple network access and services |
Band management |
Band lock, Used band status display |
APN |
Auto APN |
Bridge |
Direct connection (bridge) between mobile ISP and device on LAN |
Passthrough |
Router assigns its mobile WAN IP address to another device on LAN |
WIRELESS |
Wireless mode |
802.11 b/g/n, 2x2 MIMO, Access Point (AP), Station (STA) |
WiFi security |
WPA2-Enterprise - PEAP, WPA2-PSK, WEP, WPA-EAP, WPA-PSK; AES-CCMP, TKIP, Auto Cipher modes, client separation |
SSID/ESSID |
SSID stealth mode and access control based on MAC address |
WiFi users |
Up to 100 simultaneous connections |
Wireless Hotspot |
Captive portal (Hotspot), internal/external Radius server, built in customizable landing page |
ETHERNET |
WAN |
1 x WAN port 10/100 Mbps, compliance IEEE 802.3, IEEE 802.3u standards, supports auto MDI/MDIX |
LAN |
3 x LAN ports, 10/100 Mbps, compliance IEEE 802.3, IEEE 802.3u standards, supports auto MDI/MDIX |
NETWORK |
Routing |
Static routing, Dynamic routing (BGP, OSPF v2, RIP v1/v2, RIPng, OSPF6) |
Network protocols |
TCP, UDP, IPv4, IPv6, ICMP, NTP, DNS, HTTP, HTTPS, FTP, SMTP, SSL v3, TLS, ARP, VRRP, PPP, PPPoE, UPnP, SSH, DHCP, Telnet client, SNMP, MQTT, Wake On Lan (WOL) |
VoIP passthrough support |
H.323 and SIP-alg protocol NAT helpers, allowing proper routing of VoIP packets |
Connection monitoring |
Ping Reboot, Wget Reboot, Periodic Reboot, LCP and ICMP for link inspection |
Firewall |
Port forward, traffic rules, custom rules |
DHCP |
Static and dynamic IP allocation, DHCP Relay, Relayd |
QoS / Smart Queue Management (SQM) |
Traffic priority queuing by source/destination, service, protocol or port, traffic priority queuing by source/destination, service, protocol or port, WMM, 802.11e |
DDNS |
Supported >25 service providers, others can be configured manually |
Network backup |
VRRP, Mobile, Wired and WiFi WAN options, each of which can be used as backup, using automatic Failover |
Load balancing |
Balance your internet traffic over multiple WAN connections |
SSHFS |
Possibility to mount remote file system via SSH protocol |
SECURITY |
Authentication |
Pre-shared key, digital certificates, X.509 certificates |
Firewall |
Pre-configured firewall rules can be enabled via WebUI, unlimited firewall configuration via CLI; DMZ; NAT; NAT-T |
Attack prevention |
DDOS prevention (SYN flood protection, SSH attack prevention, HTTP/HTTPS attack prevention), port scan prevention (SYN-FIN, SYN-RST, X-mas, NULL flags, FIN scan attacks) |
VLAN |
Port and tag based VLAN separation |
Mobile quota control |
Custom data limits for both SIM cards |
WEB filter |
Blacklist for blocking out unwanted websites, whitelist for specifying allowed sites only |
Access control |
Flexible access control of TCP, UDP, ICMP packets, MAC address filter |
VPN |
OpenVPN |
Multiple clients and server can be running simultaneously, 12 encryption methods |
OpenVPN Encryption |
DES-CBC, RC2-CBC, DES-EDE-CBC, DES-EDE3-CBC, DESX-CBC, BF-CBC, RC2-40-CBC, CAST5-CBC, RC2-64-CBC, AES-128-CBC, AES-192-CBC, AES-256-CBC |
IPsec |
IKEv1, IKEv2, supports up to 4 x VPN IPsec tunnels (instances), with 5 encryption methods (DES, 3DES, AES128, AES192, AES256) |
GRE |
GRE tunnel |
PPTP, L2TP |
Client/Server services can run simultaneously |
Stunnel |
Proxy designed to add TLS encryption functionality to existing clients and servers without any changes in the programs' code |
DMVPN |
Method of building scalable IPsec VPNs |
SSTP |
SSTP client instance support |
ZeroTier |
ZeroTier VPN |
WireGuard |
WireGuard VPN client and server support |
MODBUS TCP SLAVE |
ID filtering |
Respond to one ID in range [1;255] or any |
Allow Remote Access |
Allow access through WAN |
Custom registers |
MODBUS TCP custom register block requests, which read/write to a file inside the router, and can be used to extend MODBUS TCP Slave functionality |
MODBUS TCP MASTER |
Supported functions |
01, 02, 03, 04, 05, 06, 15, 16 |
Supported data formats |
8 bit: INT, UINT; 16 bit: INT, UINT (MSB or LSB first); 32 bit: float, INT, UINT (ABCD (big-endian), DCBA (little-endian), CDAB, BADC) |
MODBUS DATA TO SERVER |
Protocol |
HTTP(S), MQTT, Azure MQTT |
MQTT GATEWAY |
MQTT gateway |
Allows sending commands and receiving data from MODBUS Master through MQTT broker |
DNP3 |
Supported modes |
TCP Master, DNP3 Outstation |
MONITORING & MANAGEMENT |
WEB UI |
HTTP/HTTPS, status, configuration, FW update, CLI ,troubleshoot, event log, system log, kernel log |
FOTA |
Firmware update from sever, automatic notification |
SSH |
SSH (v1, v2) |
SMS |
SMS status, SMS configuration, send/read SMS via HTTP POST/GET |
Call |
Reboot, Status, WiFi on/off, Mobile data on/off, Output on/off |
TR-069 |
OpenACS, EasyCwmp, ACSLite, tGem, LibreACS, GenieACS, FreeACS, LibCWMP, Friendly tech, AVSystem |
MQTT |
MQTT Broker, MQTT publisher |
SNMP |
SNMP (v1, v2, v3), SNMP trap |
JSON-RPC |
Management API over HTTP/HTTPS |
MODBUS |
MODBUS TCP status/control |
RMS |
Teltonika Remote Management System (RMS) |
IoT PLATFORMS |
Cloud of Things |
Allows monitoring of: Device data, Mobile data, Network info, Availability |
ThingWorx |
Allows monitoring of: WAN Type, WAN IP Mobile Operator Name, Mobile Signal Strength, Mobile Network Type |
Cumulocity |
Allows monitoring of: Device Model, Revision and Serial Number, Mobile Cell ID, ICCID, IMEI, Connection Type, Operator, Signal Strength, WAN Type and IP |
Azure IoT Hub |
Can send device IP, Number of bytes send/received/ 3G connection state, Network link state, IMEI, ICCID, Model, Manufacturer, Serial, Revision, IMSI, Sim State, PIN state, GSM signal, WCDMA RSCP WCDMA EC/IO, LTE RSRP, LTE SINR, LTE RSRQ, CELL ID, Operator, Operator number, Connection type, Temperature, PIN count to Azure IoT Hub server |
SYSTEM CHARACTERISTICS |
CPU |
Mediatek MIPS 24Kc 580 MHz |
RAM |
128 MB, DDR2 |
FLASH storage |
16 MB, SPI Flash |
FIRMWARE / CONFIGURATION |
WEB UI |
Update FW from file, check FW on server, configuration profiles, configuration backup, restore point |
FOTA |
Update FW/configuration from server |
RMS |
Update FW/configuration for multiple devices |
Keep settings |
Update FW without losing current configuration |
FIRMWARE CUSTOMIZATION |
Operating system |
RutOS (OpenWrt based Linux OS) |
Supported languages |
Busybox shell, Lua, C, C++ |
Development tools |
SDK package with build environment provided |
INPUT / OUTPUT |
Input |
1 x Digital Input, 0 - 6 V detected as logic low, 8 - 30 V detected as logic high |
Output |
1 x Digital Output, Open collector output, max output 30 V, 300 mA |
Events |
Email, RMS, SMS |
I/O juggler |
Allows to set certain I/O conditions to initiate event |
POWER |
Connector |
4 pin industrial DC power socket |
Input voltage range |
9 – 30 VDC, reverse polarity protection, surge protection >33 VDC 10us max |
PoE (passive) |
Passive PoE over spare pairs (available from HW revision 0007 and batch number 0010). Possibility to power up through LAN port, not compatible with IEEE802.3af, 802.3at and 802.3bt |
Power consumption |
< 2 W idle, < 7 W Max |
PHYSICAL INTERFACES (PORTS, LEDS, BUTTONS, SIM) |
Ethernet |
4 x RJ45 ports, 10/100 Mbps |
I/O’s |
1 x Digital Input, 1 x Digital Output on 4 pin power connector |
Status LEDs |
1 x bi-color connection status LED, 5 x connection strength LEDs, 4 x LAN status LEDs, 1 x Power LED |
SIM |
2 x SIM slots (Mini SIM - 2FF), 1.8 V/3 V, external SIM holders, eSIM (Optional) |
Antennas |
2 x SMA for LTE, 2 x RP-SMA for WiFi antenna connectors |
Reset |
Reboot/User default reset/Factory reset button |
PHYSICAL SPECIFICATION |
Casing material |
Aluminium housing with DIN rail mounting option, plastic panels |
Dimensions (W x H x D) |
110 x 50 x 100 mm |
Weight |
287 g |
Mounting options |
Bottom and sideways DIN rail mounting slots |
OPERATING ENVIRONMENT |
Operating temperature |
-40 °C to 75 °C |
Operating humidity |
10% to 90% non-condensing |
Ingress Protection Rating |
IP30 |